WLD2 supports zone creation. The flood sensor can call a different phone number for each zone.

WLD2 can be connected to the SensDesk portal using the HWg-Push protocol, as well as to standard monitoring systems thanks to SNMP and SNMP Trap support. Flooding can be also indicated by switching a remote output (e.g. a relay) over the network (Box-2-Box mode with a Poseidon2 or Damocles2 unit), independently for each sensing cable.
Compared to HWg-WLD, up to 4 independent detecting cables can be connected to the WLD2 to help locate the leak more accurately.

Features:

Simple installation, support for automatic network configuration via DHCP.
Intuitive WWW interface for fast and easy installation.
Ability to communicate over WiFi (external antenna for extended range, support for 2.4GHz, 2.11 b/g/n) and Ethernet at the same time.
With support for up to 4 sensing cables (each max. 85m), detection capabilities can be scaled and the source of the leak more easily identified.
The sensing cable can be fixed using clips or adhesive tape.
WLD2 signals the following states: OK / Flooded / Sensing cable fault.
Flooding alerts can be send as a standard e-mail, or as a text message (SMS) through a SMS gateway available from HW group.
Detected leaks or WLD sensing cable disconnections can be signaled by activating a relay output at a Poseidon2 or Damocles2 unit over the Ethernet.
WLD2 can be easily mounted on a wall or in a 19" cabinet.
Powered over PoE or from an external adapter.

Applications and usage:

Water detection under raised floors.
Leaky pipe detection (cable wrapped along the pipe).
Protection against floods from skylights – sensing cable routed along the walls.
Detection of water leaks in drip trays.
Detection of water leaks under air-conditioning outlets.

More information / product flyer / user manual / firmware